König Sanding paste & polish sample pack

Sample set consisting of 50 g coarse sanding paste, 50 g fine sanding paste and 100 ml friction polish.

This surface finishing set consists of two abrasive pastes, coarse and fine, and the friction polishing compound from König Holz & Harz. The coarse sanding paste sands the surface to approximately grit 1000, the fine sanding paste sands the workpiece to approximately grit 10000. The friction polish provides a glossy finish, is extremely robust, can be applied within a few minutes and then dries immediately.

The paste and polish are suitable for hardwood, stabilized wood and epoxy resin. The size of the workpiece does not matter, just follow the steps below.

The polish is made from mineral oils, alcohols and natural resins. The pastes consist of natural oils, orange oil, natural waxes and mineral abrasives, for finishing wood and resin. All products are "Made in Germany".

https://youtu.be/z7EjQ2qkxtk

Instruction sanding paste wood & resin coarse

Work on the lathe:

Sanding up to 400 grit, optional fast sanding primer.

Apply the paste with a soft cloth (easily tearing, e.g. kitchen towel) without running the machine's motor.

Then sand at a speed of 800 to 1000 revolutions per minute. Spread the paste until no residue is visible on the cloth.

Work on larger objects:

For larger surfaces, apply a small amount of grinding paste to a medium hard polishing sponge, start at approx. 800-1000 rpm. Sand until no residue remains.

If the desired result has not yet been achieved, repeat this process.

Now the surface is ready for the usual finishing.

Instructions for Sanding Paste Wood & Resin fine

After using the sanding paste wood & resin coarse or after pre-sanding to grit 1000.

Work on the lathe:

Apply the paste with a soft cloth (easily tearing, for example a kitchen towel) without running the machine's motor.

Then at a speed of 800 to 1000 revolutions per minute. Spread the paste until no residue is visible on the cloth.

Work on larger objects:

For larger surfaces, apply a small amount of grinding paste to a medium hard polishing sponge, start with approx. 800-1000 rpm. Sand until no residue remains.

If the desired result has not yet been achieved, repeat this process.

Now the surface is ready for the usual finishing.

Polishing instructions:

After using our gloss sanding paste, apply a little polish to a soft, easily tearing, lint-free cloth (kitchen towel).

Machine at approximately 500 rpm. And rub the surface of the workpiece with a lot of pressure until heat is generated.

Once the cloth is dry, add a few drops of polish again and repeat the process until the desired shine is achieved.

Subject to change without prior notice

Warning

Autoxidation in the oil-soaked cloth is accompanied by heat, which can cause spontaneous combustion of the oil-soaked cloth,

To avoid the risk of fire, never stack soaked cloths. Spread the cloth flat to dry. After drying, it can be disposed of with household waste.

The data is only indicative